TEL
+ 86-21-6420 0566
Описание товара:
MT-D2525 Gloss/ Satin/ Matt is a range of durable powder coatings specially formulated without of TGIC for use on architectural aluminium components.MT-D2525 Gloss/ Satin/ Matt is designed to offer significantly higher gloss retention and resistance to colour change combined with maximum film integrity to ensure long term cosmetic and functional protection. MT-D2525 Gloss/ Satin/ Matt typically meet the performance requirement of AAMA 2604. and Qualicoat class 2 specifications. All MT-D2525 Gloss/ Satin/ Matt powders are lead-free available in a selected range of color in full gloss such as high gloss, satin and matt finishes.
Свойства порошка
| Химический тип | Доступны в четырех великолепных цветах, чтобы дать людям больше возможностей соответствовать их спортивной одежде. |
| Уровень блеска (60°) | Depend on the colour |
| Размер частицы | Подходит для электростатического распыления. |
| Удельный вес | 1.2-1.75 g/cm³ depending on colour and effect |
| Память | Dry, cool conditions(open boxes must be resealed) |
| Срок годности | 12 months below 30°C |
| График отверждения (at object temperature) | 10 минут при 200 ° C |
Механические испытания
| Гибкость | ISO 1519 (cylindrical Mandrel) or ASTM D522 | Проход 5мм |
| прилипание | ISO 2409 / ASTM D 3359 (2mm crosshatch) | Pass Gt0 |
| Банки Эриксена | стандартами качества ISO 1520 | Pass ≥3mm |
| Ударопрочность | ISO 6272 / ASTM D2784 | Pass 2.5 Joules (reserve & direct) (20InP) |
Предварительная обработка
For maximum protection it is essential to pretreat components prior to the application of mt- D2525. Aluminium components should receive a full multi-stage chromate conversion coating or suitable chrome-free pre-treatment or suitable pre-anodising to clean and condition the substrate. Detailed advice should be sought from the pre-treatment supplier. MT-D2525 products may also be used on cast or mild steel. For outdoor use MT-PZ anti-corrosive primer over a correctly prepared substrate is recommended.
Заполнитель
MT-D2525 powders can be applied by manual or automatic electrostatic spray equipment. For solid shades, unused powder can be reclaimed up to a maximum of 30% using suitable equipment and recycled through the system. MT-D2525 powders should be applied at minimum 60µm. All powders can show small color differences from batch to batch, this is normal and unavoidable. Applicators and fabricators are advised to use a single batch for parts that will be assembled together. Differences are more likely with special effect powders. Bonded products have better application properties than blended products (more stable) but attention should still be paid to line settings in order to avoid “marble effect”and changes in aspect after recycling. A constant ratio between virgin and recycled powders should be fixed by the coater in order to achieve a consistent effect.Products with different codes should not be mixed even if same colour and gloss.
Более 20 лет опыта экспорта. Если вы готовы сделать следующий шаг или запросить бесплатные образцы, оставьте сообщение ниже, и мы ответим вам в ближайшее время.
Фабрика и отгрузка
